Every dimension belongs to an object and a drawing. Original room numbers, object marks, printed values and source regions stay together—even when the answer is unresolved.
464 of 464 photographs have extraction records, containing 27,517 properties. Initial image review is not exhaustive extraction: 0 photographs have passed the full-region check. 66 numbered sheets are reconciled. Modeling and architectural registration are separate work; these counts do not establish a complete building.
Download the structured register (JSON)Object: Floor fill, slab and continuous angle requirements
Printed values, calculations, image traces and observed counts are different kinds of evidence. “Verified” applies to the specific reading—not to the whole room or model.
7 in
Section property of angles covered by note; actual installed member instances unresolved.
Drawing notation: ALL 7 × 3½ × ⅜ L's FULL LENGTH OF EACH BAY
Section property of angles covered by note; actual installed member instances unresolved.
3.5 in
Second leg of angle section.
Drawing notation: ALL 7 × 3½ × ⅜ L's FULL LENGTH OF EACH BAY
Second leg of angle section.
0.375 in
Printed section fraction read from master crop; OCR not used as measurement.
Drawing notation: ALL 7 × 3½ × ⅜ L's FULL LENGTH OF EACH BAY
Printed section fraction read from master crop; OCR not used as measurement.
Requirement applies to specified angle family; does not establish numerical bay length.
Drawing notation: FULL LENGTH OF EACH BAY
Requirement applies to specified angle family; does not establish numerical bay length.
4 in
Printed general floor-fill requirement; exceptions and finishes not transferred to room geometry.
Drawing notation: FLOOR FILL 4″
Printed general floor-fill requirement; exceptions and finishes not transferred to room geometry.
3.5 in
Explicit lower-slab note.
Exception modifies floor fill and lower slab requirements; exceptions not exhaustively located.
Drawing notation: EXCEPT AS NOTED
Exception modifies floor fill and lower slab requirements; exceptions not exhaustively located.
Illustrative (-5″) symbol demonstrates convention; not assigned to any individual member.
Drawing notation: ELEVATIONS OF STEEL SHOWN THUS [illustrative offset] ARE TO TOP OF STEEL
Illustrative (-5″) symbol demonstrates convention; not assigned to any individual member.
W403 notation plural; W404 prints FOR SLAB DETAILS SEE SH No 413; companion not reviewed.
Drawing notation: FOR DETAILS OF SLABS SEE SH No 413
W403 notation plural; W404 prints FOR SLAB DETAILS SEE SH No 413; companion not reviewed.
Source inventory is separate from the floor filters above. Select one drawing to inspect it; no drawing set is preloaded.